![]() Some are even older USB 2 cables simply dressed up with a newer USB-C plug on the end of them. ![]() Some are for power only, some for data and some are for both. Some USB-C cables are USB 3.1 Gen 1 compliant, some are USB 3.1 Gen 2 compliant. Confusingly, there are many different USB-C cables out there, but on the outside, they all look the same. The Solutionįrom other reports, it seemed to be an issue with the type of USB-C cables that are used. So I tried this, and that didn’t work either.Īfter some searching around on the DJI forums, it turns out I’m not the only one struggling with this. There are certainly some devices out there that need to be off, in order to switch into “mass storage mode” and be recognized as a drive. ![]() I then started to wonder whether the drone was supposed to be switched on or off when I was doing this. I tried a USB-C to USB-C cable, and a USB-C to USB-A cable, both plugged into a Thunderbolt hub that was connected to my Mac. When I plugged my Mavic Air 2 into my Mac, it did not show up as an external drive. And frankly, DJI, it is something that needs to be fixed! All of DJI’s drones have a USB-C port on them, so you would think that the solution is simply to plug the drone into your computer with a USB-C cable, right? Unfortunately it’s not necessarily that simple. This proved to be harder that I thought it would be. That’s great, but how do you get that footage off the drone when you get home? I had filled my Mavic’s MicroSD card and immediately the drone switched to recording additional footage and photos onto the 8GB of built-in memory. While this is ideal, I recently ran into a problem. ![]() The best way to get footage of your Mavic Air 2 is to use a MicroSD card in the drone, and then simply remove the card and plug it into a card reader. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |